ESC-CRU Series

U PROFILE SHEET PILES

The ESC-CRU series is a cold rolled sheet pile profile. U-shaped steel sheet piles have long been familiar to designers and constructors because of the long-standing traditions and technologies, and are widely used for permanent structures, temporarily installed soil-retaining construction and temporary cofferdams. ESC-CRU profiles provide an economic alternative to Hot Rolled U Sheet Piles as they are of similar size and possess similar structural properties, with a  section modulus ranging from 500cm3/m all the way up to 4,650cm3/m. With over 50 choices in profile, the CRU series sheet piles allow greater fine tuning in the design for the most economical solution.

Section Modulus Range

​1100-5000cm3/m

Width Range (single)

​580-800mm

Thickness Range

​5-16mm

Production Standards

​BS EN 10249 Part 1 & 2

​Steel Grades
  • Q235B, Q345B, Q345C, Q390B, Q420B

  • S235JR, S275JR, S355JR, S355JO

  • ASTM A572 Gr42, Gr50, Gr60

  • Others available on request

Length

35.0m maximum

Any project specific length can be produced

Delivery Options
  • Single or Pairs

  • Pairs either loose, welded or crimped

  • Lifting Hole

  • Grip Plate

  • By container (11.8m or less) or Break Bulk

  • Corrosion Protection Coatings

Corner Piles

ESC is able to offer 3 options for Corner Pile configurations in the ESC-CRU Series. Option 1 is frequently used when the installation contractor prefers to create their own corner piles on site depending on the as-driven layout. However this produces wastage on the offcut pile. Option 2 allows welding at the mill or on site and provides the installation contractor with more flexibility on  corner pile location. Option 3 provides an option with no welding required and provides increased accuracy at corners that are deviated from the typical 90˚ corner.

Other Configurations

ESC-CRU Series Sheet Piles can be combined to create special arrangements. These combined sections presented can greatly amplify the bending strength of a single section by over 5 times. Box Piles with intermediate standard U Piles can be designed. The welded box section can also be incorporated along a certain section of the length where the bending moments are the highest. Please contact our engineering department at engineering@escpile.com if you would like to receive more information about the presented combined pile systems.

 

Technical Information

Datasheets
Drawings
Brochure
Show More

Product Case Studies

Show More
 

Contact

ESC Steel Philippines, Inc.

Manila Office

6/F Cyber One Building,
11 Eastwood Avenue,
Eastwood City Cyberpark, Bagumbayan,
Quezon City
Philippines

T: +632 8464 9383

M(Globe): +63 917 202 7798

M(Smart): +63 920 504 3801

E: manila@escsteelphil.com

E: philippines@escpile.com

Cebu Office

5/F Unit 534 Regus Park Centrale Building, Apas,

IT Park, Cebu City, 
Philippines

T: +633 2494 9523

M(Globe): +63 917 561 0070

E: cebu@escsteelphil.com

  • Grey LinkedIn Icon
  • Grey Facebook Icon
  • Grey Twitter Icon
  • Grey YouTube Icon
  • Grey Instagram Icon